LBL Lighting MO Surf Mag Xfmr 600w 277v/12v - Manual (Page 2)

5
2
Mount the crossbar to the electrical box with the provided
two #8-32 screws.
Mount the Back Plate
1A
1
1B
2
1
3
Loosen the three #8-32 flat head screws (Do Not Remove)
with the provided 3/32 Allen wrench.
Rotate the backplate counter clockwise so that the #8-32 flat
head screws are lined up with vertical cut out portion of the
"L" slots.
Remove the backplate from the housing.
2
3
#8-32 SCREW
BACKPLATE
4 4
#8-32 FLAT
HEAD SCREW
BACKPLATE 3/32 ALLEN
WRENCH HOUSING
2
Adjust the Height
TRANSFORMER
HOUSING
2A
CIRCUIT
BREAKER
NUT
CIRCUIT
BREAKER
1 Unscrew and remove the circuit breaker nuts of each
individual circuit breaker from the transformer housing.
Gently pull out and remove the two circuit breakers from the
transformer housing.
2
CIRCUIT
BREAKER
CIRCUIT
BREAKER
NUT
2B
3
4
5
6
7
8
9
10
POWER FEED
WIRES
NUT
WASHER
SAFETY WIRE
TRANSFORMER
11
NIPPLE
3
4
5 CIRCUIT
BRAKER
TRANSFORMER
HOUSING
6
SET SCREW
STRAIN RELIEF
Loosen the center nut inside the transformer housing, then
remove the center nut, washer, and the safety wire.
Gently pull out the transformer to expose the power feed
wire connections.
Take note of the wire connections and remove the wire nuts
to disconnect the power feed wires from the transformer
output wires and the circuit breaker wires.
Loosen the set screws on both sides of each strain relief
and pull out the power feed wires.
Cut the end power feed wires to the desired length.
With a sharp knife cut 1" from the end of the wire web
and separate the wires 8" from each other.
Push the power feed wires through the strain reliefs
leaving at least 6” of cord in the back of the transformer
housing for wire connections and tighten the set screws.
Strip 1/2" off the wire ends and reconnect the power
feed wires to their original connections.
Reinstall all the parts, taking caution of the wires and
wire connections, onto the nipple by reversing step 1.
Reinstall the circuit breakers by reversing section 2A. 12
5
5