LBL Lighting MO Bracket - Manual (Page 3)

3
Insert the aircraft cable completely into the slotted cable post.
Pull the aircraft cable so that the strain relief sits against the
slot.
AIRCRAFT CABLE
SLOTTED CABLE POST
Screw in the slotted cable post completely onto the threaded
washer.
Insert the Monorail through the plastic insulator.
Install the Monorail
For all standoffs, slightly loosen the two (Do Not Remove)
M3 set screws on the side of the housing with the 1.5MM Allen
wrench to ease inserting the Monorail.
PLASTIC INSULATOR
1.5MM ALLEN WRENCH
M3 SET SCREW
PLASTIC INSULATOR
MONORAIL
STRAIN RELIEF
THREADED WASHER
Remove the M3 set screw on the housing next to the standoff
rod with the 1.5 MM Allen wrench.
Tighten the cable connector post completely into the housing
thread hole.
CABLE CONNECTOR POST
AIRCRAFT CABLE
SLOTTED POST
Insert the aircraft cable into the cable connector post.
Pull aircraft cable until it is taut and secure it by tightening the
M3 set screw on the cable connector post with the 1.5MM
Allen wrench.
Repeat steps 6 through 11 for the remaining standoffs.
30 º
3C
3D
3E
6
7
8
9
3F
3G
4A
4B
10
11
12
1
2
7
6
10
8
9
2
1
11