LBL Lighting LED Illum MO Surf Mag Xfmr 600w 277v/12v - Manual (Page 2)

2
Adjust the Power Feed Height
The overall length of the transformer (from top of the
transformer to bottom of the power feed connectors) is 40".
The transformer height (H) is measured from top of the
transformer to top of the LED-Illuminated Monorail (when it is
installed) which is about 38.5" when the power feed height is
not adjusted. the power feed cord more than DO NOT CUT
30".The minimum transformer height (H) is 9".
NOTE: It is recommended to adjust the power feed
height before installing the transformer.
33"
36"
4"
H
Determine the transformer height (H).Always add 2" to the
desired height so that there is no tension on the cord when it
is installed. For example, if the desired transformer height (H)
is 12", then cut the power feed cord 24.5" (38.5" - 14" = 24.5")
shorter.
With a sharp cutter cut the power feed cord to the desired
length.
Starting with one power feed, remove the power feed cap from
the power feed housing.
Loosen the two M3 set screws on power (Do Not Remove)
feed housing with the provided 1.5MM Allen wrench.
POWER
FEED CAP
POWER FEED
HOUSING
1.5MM ALLEN WRENCH
M3 SET SCREW
Slide the power feed housing down to expose the metal tube.
Open the metal tube slot to unwrap and remove it from the
cord. Discard the metal tube.
POWER FEED
HOUSING
METAL TUBE
CONTACT POST
INSULATED
BUSHING
M3 SET SCREW
1.5MM ALLEN WRENCH
Slide the insulated bushing down to expose the contact post.
Loosen the M3 set screw with the 1.5MM (Do Not Remove)
Allen wrench.
Remove the contact post, insulated bushing, and power feed
housing.
POWER FEED HOUSING
1A 1A 1A 1C
1A 1B
1A 1D
1
2
3
4
6
5
7
8
1A 1E
9
10
3 2
7
8
8
4
5
10
6