LBL Lighting Fusion Jack Canopy 3 Light Rectangle LED - Manual

Installation Instructions for
3 Rectangle Fusion Jack Canopy 1.1 CK003R-FJ_
980FSJ3PLC
G P I : ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product can be dimmed with a standard incandescent dimmer.
1
Install the Canopy
#8-32
SCREW
MOUNTING PLATE
CANOPY HOUSING
Remove the six #8-32 screws on the sides of the canopy
housing.
Lift the mounting plate from the canopy housing.
MOUNTING PLATE
With a hammer tap the anchors at the marked points into the
ceiling up to the threaded portion.
Screw the anchors in the rest of the way with a Phillips
screwdriver.
ANCHOR
ANCHOR
Feed the power line wires through the mounting plate
center hole.
Line up the two mounting plate slots with the electrical box
holes and use the two provided #8-32 screws to mount it to
the electrical box.
#8-32 SCREW
Align the mounting plate slots with the electrical box holes and
mark two points onto the ceiling through the mounting holes.
Fusion Jack
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1
2
3
4
5
1A 1C
1B 1D
6
7
1 2 1 1
3 3
4 5
7 7