LBL Lighting Fusion Jack Canopy 2.75" Round LED - Manual (Page 2)

2
Mount the canopy to the electrical box with the two #8-
32 screws using the provided 3/32 Allen wrench.
#8-32 SCREW
ALLEN
WRENCH
Screw the Fusion Jack into the Fusion Jack port.
Turn the power on.
Connect each canopy wire to a low voltage wire with a
wire nut.
Place all wire and wire nut connections properly inside
the electrical box.
LOW VOLTAGE
WIRES
CANOPY
Adjust the front bracket so that it is flush with the
drywall.
Replace and tighten the two remaining #6 screws on
the front bracket to secure it in place.
1
1C
1D
8
11
7
9
10
8
8
11
11
9
9
12
13
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2009 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
1E
1F
FUSION JACK PORT
FUSION JACK 12
#6 SCREW
FRONT
BRACKET