LBL Lighting Fusion Jack Canopy 2.75" Round LED User Manual
Fusion jack 2.75" flush canopy, Install the 2.75" canopy

1
Installation Instructions for
Install the 2.75" Canopy
G
P
I
:
ENERAL RODUCT NFORMATION
This product is suitable for dry locations only.
Model numbers ending in “-LED” or “-LED277” can be dimmed
with a low-voltage electronic dimmer, have a rated maximum output
of 60 watts, and are compatible with LED elements.
All other model numbers can be dimmed with a standard
incandescent dimmer, have a rated maximum output of 75 watts,
and are not compatible with LED elements.
Disconnect power to the electrical box.
Connect the green transformer wire to a suitable ground
according to local electrical codes.
Connect the white transformer wire to the neutral
power line wire with a wire nut.
Connect the black transformer wire to the hot power
line wire with a wire nut.
Place the transformer inside the electrical box.
TRANSFORMER
2” ELECTRICAL BOX
Fusion Jack
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Insert the front bracket into the 2” electrical box.
FRONT BRACKET
2" ELECTRICAL BOX
Fusion Jack 2.75" Flush Canopy
1.1
CK001I-FJ2-_
980FSJ2C
Fusion Jack
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1A
4
2
3
5
6
1B
1
2
3
4
5
NOTE:
The 2” electrical box must be installed prior to
these steps. Refer to the instruction sheet provided with
the electrical box.