LBL Lighting 2-Circuit MO Direct Feed Canopy User Manual
4" round single-post power feed canopy, Install the power feed canopy, Installation instructions for

Installation Instructions for
980MR24RDSPFC
1
4" Round Single-Post Power Feed Canopy
1.0
REMOTECNPYDIR_-2C
G
P
I
:
ENERAL
RODUCT NFORMATION
This product is suitable for indoor dry locations only.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeter).
Place all wires and wire nut connections inside the electrical
box.
Tighten the two provided #8-32 flat head screws to the
electrical box holes with the 3/32 Allen wrench to secure the
canopy in place.
#8-32 FLAT
HEAD SCREW
3/32 ALLEN WRENCH
Install the Power Feed Canopy
NOTE:
The low voltage wires should be present in the
electrical box prior to these steps. Refer to the instructions
provided with the remote transformer to install the remote
transformer and low voltage wires.
CANOPY
Connect the power feed wire coming out of the middle
contact (the wire coming out of the knurled cap) to the low
voltage wire marked "HOT 2" with a wire nut.
Connect the center power feed wire (that is attached to the
top contact) to the low voltage wire marked "HOT 1" with a
wire nut.
Connect the remaining side wire to the low voltage wire
marked "COM" with a wire nut.
NOTE:
Use the provided universal round crossbar when
the canopy holes do not line up with the electrical box
holes.
HOT 2
HOT 1
COM
WIRE COMING FROM
MIDDLE CONTACT
CENTER WIRE
TOP CONTACT
SIDE WIRE
1A
1
2
3
4
5
1A
3
2
2-Circuit Monorail
1
1A
1B
5
5