LBL Lighting 2-Circuit MO 4" Round Canopy - Manual (Page 2)

2
Properly place the all the wires and wire nut connections
into the electrical box.
Mount the canopy to the electrical box/mounting plate
with two #8-32 screws provided.
8 11
8 12
1C
#8-32
SCREW
Connecting the Center Power Feed
Connector to the MonoRail
1
12
12
SCREW
POWER FEED CAP
POWER FEED
HOUSING
MIDDLE
CONTACT
Remove the power feed cap from the power feed housing.
Completely back out the screw on the power feed cap.
Loosen (Do Not Remove) the set screw and knurled cap on
the power feed housing, and pull the middle contact wire
slightly out so that the middle contact is not exposed.
NOTE: The standoffs should be installed to support the
2-Circuit Monorail while connecting 2-Circuit Monorail to
the power feed canopy. Refer to the instructions provided
with the standoffs.
2A
2
3
1
1
2
3
POWER FEED CAP
2-CIRCUIT MONORAIL
POWER FEED
HOUSING
Place a 2-Circuit Monorail section into the standoffs and
power feed housings.
Screw the power feed cap completely to the power feed
housing. Make sure that the power feed cap is not cross
threaded.
POWER FEED CAP
SCREW
KNURLED CAP
HOT 1
HOT 2
COM
Tighten the screw on the power feed cap for proper power
connection.
Tighten the knurled cap for proper power connection, and
tighten the set screw near the knurled cap.
2B
4
5
6
7
2C
4
5
7
6
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting. All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
A Generation Brands Company