beautypg.com

LBL Lighting 2-Circuit MO 4" Round Canopy User Manual

4” single flexible power feed canopy, Install the canopy, Installation instructions for 700mopcen

background image

Installation Instructions for

700MOPCEN_

1

4” Single Flexible Power Feed Canopy

980MR2ASPFC

1.0

REMOTECNPY_-2C

Loosen (Do Not Remove) the 3 set screws on the strain
relief.

Before cutting the center power feed wires to the
desired length, move the wire identification tags (HOT1,
HOT2, and COM) down the wire.

Cut the end power feed wires to the desired length.

With a sharp knife cut 1" from the end of the wire web
and separate the wires 8" from each other.

Push the power feed wires through the strain relief
leaving at least 6” of cord in the back of the canopy for
wire connections.

Re-tighten the set screws.

2

3

4

1

1A

Strip 1/2" off the wire ends.

Connect the center power feed wire marked "HOT1" to
electrical box marked "HOT1" with a wire nut.

Connect the center power feed wire marked "HOT2" to
electrical box wire marked "HOT2" with a wire nut.

Connect the power feed wire marked "COM" to electrical
box wire marked "COM" with a wire nut.

7

1B

8

Note : If mounting the canopy onto an octagonal
electrical box, first mount the provided universal
mounting plate before proceeding to this step.

8

5

SET SCREW

STRAIN RELIEF

1

HOT 1

HOT 2

COM

1

6

9

10

10

9

Install the Canopy

NOTE:

Low voltage wires must be present in

electrical box before proceeding with these steps.
Refer to the instructions provided with the remote
transformer.

NOTE:

The Power Feed wires may be connected

directly to the transformer, Refer to the instructions
provided with the remote transformer for connection
details.

GENERAL PRODUCT INFORMATION:

This product is suitable for indoor dry locations only.

This product must be used with LBL Lighting 2-Circuit MonoRail

system only.

SPECIAL INSTALLATION

Table of contents