LBL Lighting Galleria Shield W - Manual (Page 2)

2
1E
Place the fixture canopy onto the backplate. Level the fixture
vertically and tighten the two M3 set screws with the 1.5MM
Allen wrench to secure the fixture in place.
Push the fixture arm with the wire completely into the bushing
and tighten the M4 set screw with the 2MM Allen wrench.
Connect each transformer low voltage wire (red wire) to one
fixture wire with a wire nut.
Place all wires and wire nut connections inside the electrical
box.
CANOPY
M3 SET SCREW
1.5MM ALLEN WRENCH
M4 SET SCREW
2MM ALLEN WRENCH
FIXTURE ARM
BUSHING
Line up two backplate holes with the electrical box holes.
Mount the backplate to the electrical box with the two #8-32
screws provided.
In accordance with local electrical codes, make sure that the
backplate and the transformer green wire are grounded.
BACKPLATE
ELECTRICAL BOX HOLE
#8-32 SCREW
7
1C
8
10
8
7
7
6
6
9
11
1D
10
10
9
12
12
12