LBL Lighting Tulip WCF - Manual (Page 2)

1C
MOUNTING
PLATE
6
7
Place all wires and wire nut connections properly inside the
electrical box.
Slide the mounting plate center hole onto the exposed
threaded nipple. Secure the mounting plate to threaded nipple
with both washer and nut.
2
SAVE THESE INSTRUCTIONS!
EXPOSED
THREADED
NIPPLE WASHER
NUT
Push the lamp pins completely into the socket holes. 1
2A
Install the Lamp & Shade
For The Fixtures With Electronic Ballast,
Use
MAX 13 Watt Type Quad Tube G24q-1
Base 4-PIN Compact Fluorescent Lamp.
2B
2
GLASS
SHADE
Place the glass shade onto the mounting plate. Align the glass
shade holes with the mounting plate holes. Tighten the thumb
screws to secure the glass shade in place.
THUMB
SCREW
MOUNTING
PLATE
LAMP
SOCKET
2
2
6
7
1
For The Fixtures With Magnetic Ballast,
Use
MAX 13 Watt Type Quad Tube
GX23-2 Base Compact Fluorescent Lamp.
NOTE: Do not over tighten the thumb screws which may
cause the glass shade to break.
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2008 LBL Lighting. All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company