LBL Lighting Taitu W - Manual

Installation Instructions for
Taitu 1.4 HWAP19OCSC2M100
980TAITUW
G P I : ENERAL RODUCT NFORMATION
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product is suitable for damp locations.
This product can be dimmed with a standard incandescent dimmer.
Install the Fixture
1
Make sure the two outer threaded holes on the universal
crossbar are positioned at 45 ˚ degree diagonal, so that they
match with the mounting bracket slotted holes.
Line up two universal crossbar slots with the two electrical
box holes and secure it to the electrical box with the two
#8-32 screws provided.
#8-32 SCREW
UNIVERSAL CROSSBAR
OUTER THREADED HOLE
Make sure that the universal crossbar is grounded in
accordance with local electrical codes.
Connect the fixture white wire to the neutral power line wire
with a wire nut.
Connect the fixture black wire to the hot power line wire with
a wire nut.
SLOT
ELECTRICAL
BOX HOLE
1A 1B
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Wall
1 3
1
5
2
4
5
1
2
2
4