LBL Lighting 4 Round Dual-Post Direct Power feed Canopy - Manual (Page 2)

2
Install the Monorail the Power Feed
Canopy
Push two Monorail sections completely onto the straight
isolating connectors.
Tighten the M3 set screws firmly with the provided 1.5 MM
Allen wrench. the set screws which Do Not Over Tighten
may strip the thread.
M3 SET SCREW
1.5 MM ALLEN
WRENCH
MONORAIL MONORAIL
STRAIGHT ISOLATING CONNECTOR
Remove the power feed caps from the power feed housings.
Completely back out the screw on the power feed caps.
NOTE: The standoffs should be installed to support the
Monorails while connecting Monorails to the power feed
canopy. Refer to the instruction provided with the
standoffs.
POWER FEED
HOUSING
SCREW
POWER
FEED CAP
SCREW
POWER FEED CAP
Place the combined Monorail sections into the standoffs and
power feed housings so that the straight isolating connector
section is located in the middle of the two power feed
housings. Make sure that the Monorail sections are
electrically isolated from each other.
Screw the power feed caps completely to the power feed
housings. Make sure that the power feed caps are not cross
threaded.
Tighten the screw on the power feed caps for proper power
connection.
NOTE: It is recommended that two people install the
Monorail sections to the standoff and power feed
housings.
STRAIGHT ISOLATING CONNECTOR
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
A Generation Brands Company
1A
1
2A
2
2
1A 2B
1A 2C
1
4
3
5
6
7
3
4
5
6
7