LBL Lighting 4 Round Dual-Post Direct Power feed Canopy User Manual
4" round dual-post direct power feed canopy, Install the power feed canopy, Installation instructions for

Installation Instructions for
4" Round Dual-Post Direct Power Feed Canopy
980MRL4RDDPFC
1
1.2
REMOTECNPYDIRDF_
Install the Power Feed Canopy
G
P
I
:
ENERAL
RODUCT NFORMATION
This product is suitable for indoor dry locations only.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeter).
NOTE:
The low voltage wires should be present in the
electrical box prior to these steps. Refer to the instructions
provided with the remote transformer to install the remote
transformer and low voltage wires.
CANOPY
Starting with one post, connect the wire attached to the
center contact to the low voltage wire marked "HOT 1" with a
wire nut.
Connect the other wire of the same post to the low voltage
wire marked "COM 1" with a wire nut.
Connect the wire attached to the center contact of the other
post to the low voltage wire marked "HOT 2" with a wire nut.
Connect the other wire of the post to the low voltage wire
marked "COM 2".
NOTE:
Use the provided universal round crossbar when
the canopy holes do not line up with the electrical box holes.
CENTER CONTACT
HOT 1
HOT 2
COM 1
COM 2
Place all wires and wire nut connections inside the electrical
box.
Tighten the two provided #8-32 flat head screws to the
electrical box holes with the 3/32 Allen wrench to secure the
canopy in place.
#8-32 FLAT
HEAD SCREW
3/32 ALLEN WRENCH
Monorail
1A
1A
1
1
2
3
4
2
4
3
1A
1B
6
6
5
6