LBL Lighting Dual-Post Direct Power feed Canopy - Manual

Installation Instructions for
2” Dual-Post Direct Power Feed Canopy
980MRL2RDDPFC
Monorail
1
1.1 REMOTECNPDIRDF2_
Install the Power Feed Canopy
GENERAL PRODUCT INFORMATION:
This product is suitable for indoor dry locations only.
1A
1
2
3
4
2" ELECTRICAL BOX
CEILING
WIRE NUT
SIDE
SCREWS
MOUNTING
PLATE
HOT 1
COM 1
HOT 2
COM 2
2
NOTE: The 2" electrical box should be installed prior to
these steps. Refer to the instruction provided with the 2"
electrical box.
1
2 3
4
Starting with one post, connect the center wire to the conduit
wire marked "HOT 1" with a wire nut.
Connect the side wire to the conduit wire marked "COM 1"
with a wire nut.This post will power one feed of the
MonoRail.
Connect the center wire of the other post to the conduit
wire marked "HOT 2" with a wire nut.
Connect the side wire to the conduit wire marked "COM 2"
with a wire nut.This post will power the other feed of the
MonoRail.
Remove the two side screws on the canopy with an Allen
wrench.
Attach the mounting plate to the 2” electrical box with two
#8-32 screws and reattach the canopy to the mounting plate
with the side screws.
5
5
6
6
Install the Monorail to the Power
Feed Canopy
Push two Monorail sections completely onto the straight
isolating connectors.
Tighten the M3 set screws firmly with the provided 1.6 MM
Allen wrench. the set screws which
may strip the thread.
Do Not Over Tighten
1
M3 SET SCREW
1.6 MM ALLEN
WRENCH
MONORAIL MONORAIL
STRAIGHT ISOLATING CONNECTOR
2A
2
1
2