LBL Lighting Gypsy SCF - Manual (Page 2)

2
Install the Fixture
3A
NOTE: Make sure to support the fixture while
adjusting the aircraft cables. An assistant is
recommended to complete the remaining steps.
Feed the aircraft cables through the cable clutches in
the canopy.
Evenly pull the aircraft cable up through the canopy to
raise the fixture to the desired length.
Cut off the excess aircraft cable leaving enough for fine
leveling later.
If necessary loosen the set screw in the strain relief and
feed the power cord from the fixture into the canopy
port.
2 1
2 2
2 3
2 4
SET
SCREW
NOTE: The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer that the drop height of the
fixture.
Once the desired length is determined, tighten the set
screw, leave 6 inches of the power cord behind the
canopy and cut off the extra cord. 2 5
AIRCRAFT
CABLE AIRCRAFT
CABLE
POWER CORD
STRAIN
RELIEF
CABLE
CLUTCH CABLE
CLUTCH
1
3
4
5
2B
2A
FIXTURE SCREW
1
Remove the two fixture screws located on top of the
fixture. 2 1
Remove the top portion of the fixture to reveal the lamp
sockets. 2 2
LAMP
LAMP SOCKET
LAMP SOCKET
Line up the lamp pins into the sockets and rotate the
lamps to lock it in place.
Reassemble the fixture (reversal of figure 2A and 2B).
use type T5 high output linear
fluorescent lamp.
MAX 39 Watt
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
3
3
2C
2 3
2 4
Install the Lamp