LBL Lighting Mezzo 3-Light S - Manual (Page 2)

2
Shorten the Pendants (optional)
Disconnect all of the wire connections.
Loosen the set screw on all 3 strain (Do Not Remove)
reliefs.
Adjust each fixture’s height (from bottom of the fixture
shade to top of the canopy) by pulling the cords up trough
the canopy while pushing them through from the stem.
When desired height is achieved, tighten the set screws
on the strain . reliefs
2A
1
STRAIN
RELIEF SET
SCREW
STEM
CORD
CORD
2
3
4
2B
4"
Leave 6" of the cord behind the canopy for power
connections. Cut the excess cord.
From the end of the cord, strip the insulation 4" using a
sharp knife. . Make sure not to nick the inner wires
Strip the end of the wires.
Reconnect the wires to their original connections.
6
7
5
8
3A
Connect the mounting plate ground wire to a suitable
ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
Connect the black fixture wire to the hot power line
wire with a wire nut.
1
2
3
1
2 3
Install the Fixture