LBL Lighting Bling Chandelier - Manual (Page 3)

3
2B
Connect the bare power cord wire and copper backplate wire
to a suitable ground according to local electrical codes.
Connect the power cord wire with the white strip to the
neutral power line wire with a wire nut.
Connect the other power cord wire to the hot power line
wire with a wire nut.
9
10
11
10 11
9
2C
Place all wires, wire nuts, and cables inside the canopy.
Line up the canopy with the backplate and reinstall all four
screws.
12
13
13 13
2D
Adjust the aircraft cables until the boom is level. Feed the cable
into the cable clutch to raise the boom. Push in on the cable
clutch nipple to release the cable and lower the boom.
14
SCREW SCREW
CABLE
CLUTCH
NIPPLE
AIRCRAFT
CABLE
14
3A
LAMP
Push the lamp pins completely into the socket holes. 1
NOTE: Use only your fingers and a soft cloth to install
the lamp.
SOCKET
Use Watt Bi-Pin Xelogen
(Xenon) Lamp.
MAX 10
1
Install the Lamp & Shade
3B
SOCKET
Push the glass shade completely onto the spring clip.
Repeat for all the lamps.
2
SPRING CLIP
GLASS SHADE
2
3