LBL Lighting Bling Chandelier - Manual (Page 2)

2
1F ELECTRICAL BOX
Feed the power line wires through the center backplate hole.
Mount the backplate to the electrical box with the two #8-32
button-head screws provided.
Secure the backplate to the anchors with the two
countersunk-head screws.
9
BACKPLATE
SCREW SCREW
POWER LINE WIRES
10
SCREW SCREW
ANCHOR
11 11
9
10 10
11
Attach the Canopy and Boom
1E
Line up an anchor tip with one of the marks on the ceiling, and
push the anchor into the ceiling up to the threads.
Screw the anchor in the rest of the way with a screwdriver.
Repeat steps 6-7 for the other anchor.
6
ANCHOR ANCHOR
MARK
7
8
6
7
2A
POWER
CORD
POWER
CORD
AIRCRAFT
CABLE
AIRCRAFT
CABLE
CABLE
CLUTCH
CABLE
CLUTCH
CABLE
CLUTCH
BOOM
Feed the aircraft cables from the boom into the cable clutches
in the canopy.
Adjust the aircraft cable to the approximate length desired.
Attach the safety coupler to each aircraft cable. Leave some
extra length in the cable for later adjustment and cut off the
excess cable.
Feed the power cord from the boom into the canopy port.
Slide the strain relief onto the power cord and tighten the
screw. The power cord is not intended to
support the boom.
Leave at least 8" of the cord behind the canopy for power
connections and cut the excess cord.
Remove the last 4" of the power cord insulation.
Strip 1/4" of the insulation from the wire ends.
Leave some slack:
1
CANOPY
CANOPY
AIRCRAFT
CABLE STRAIN
RELIEF
SAFETY
COUPLER
5
4
1
3
1
3
6 3
4
8
2
3
4
5
6
7
8