LBL Lighting Mademoiselle S - Manual (Page 2)

2
NOTE: The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer that the drop height of the
fixture.
Once the desired look is determined, tighten the set screw on
the strain relief.
Mark the cord underneath the strain relief.
1D
CORD
9
2 8
2 9
1E
4"
Leave 6" of the cord behind the canopy for power connections.
Cut the excess cord.
From the end of the cord, strip the insulation 4" using a sharp
knife. . Make sure not to nick the inner wires
Strip the end of the wires.
7 10
7
7
11
12
Mount the Fixture
2A
#8-32
SCREW
CROSSBAR
Mount the crossbar assembly to the electrical box with
the two provided #8-32 screws. 1
1 1
2B
10 2 2
2 3
2 4
Reconnect the power cord wires to their original connections
(reversal of 2A).
Ground the fixture to a suitable ground in accordance
with local electrical codes.
Connect the white ballast wire to the neutral power line
wire.
Connect the black ballast wire to the hot power line
wire. 2 5
4
5
3
2
2
3