Install the canopy – LBL Lighting Calix 7-Light User Manual
Page 3
3
POWER
CORD
STRAIN
RELIEF
3B
SET SCREW
Loosen
the 2 set screws on the strain
(Do Not Remove)
relief.
Pull the power cords through the strain relief to the
desired length and re-tighten the 2 set screws.
Leave at least 6” of cord in the back of the canopy for
wire connections and trim off the excess cable.
From the end of the cord, strip the insulation 4" using a
sharp knife.
.
Make sure not to nick the inner wires
Strip the end of the wires.
Reconnect the power cord wires to their original
connections to the driver (reversal of 2A).
3
4
2
5
6
7
Install the Canopy
4A
10
2
1
2
2
2
3
Ground the fixture to a suitable ground in accordance
with local electrical codes.
Connect the white driver wire to the neutral power line
wire.
Connect the black driver wire to the hot power line
wire.
3
2
3
1
POWER
CORD
DRIVER
3
4
- KENDALL (2 pages)
- LINNET PENDANT (1 page)
- MEZZO GP (4 pages)
- MEZZO GPCF (4 pages)
- MEZZO P (4 pages)
- MEZZO PCF (4 pages)
- MILO S (4 pages)
- MILO SCH (4 pages)
- RHUTHM S (2 pages)
- SOMEDAY GP (2 pages)
- SOMEDAY GPCF (2 pages)
- SOMEDAY P (2 pages)
- SOMEDAY CF (2 pages)
- Isla SP (1 page)
- Mason Classic (1 page)
- Mason SP (2 pages)
- Mason SPCF (2 pages)
- Aiko SP (1 page)
- Aiko SPCF (1 page)
- Olivia SP (1 page)
- Olivia SPCF (1 page)
- Zuri P (2 pages)
- Vera P (2 pages)
- Vera PCF (2 pages)
- Tindra P (4 pages)
- Akari P (1 page)
- Akari PCF (1 page)
- Isis GP (2 pages)
- Isis GPCF (2 pages)
- Rock Candy Cylinder SP (1 page)
- Rock Candy Cylinder SPCF (1 page)
- Miyu Classic SP (1 page)
- Miyu SP (2 pages)
- Miyu SPCF (2 pages)
- Sora SP (2 pages)
- Sora SPCF (2 pages)
- Julep S (2 pages)
- Julep SCF (2 pages)
- Pavia (2 pages)
- Rhythm PCF (2 pages)
- Rhythm P (2 pages)
- Juniper SF (4 pages)
- Juniper SFCF (4 pages)
- Alaya SP (4 pages)
- Icicle II SP (2 pages)