LBL Lighting Calix 7-Light - Manual (Page 2)

2
Prepare the Canopy
2B
#8-32
SCREW
CROSSBAR
Mount the crossbar assembly to the electrical box with
the two provided #8-32 screws. 2
2 2
Screw the cable post completely to the threaded nipple.
CABLE POST
THREADED NIPPLE
1C
6
6
7 Feed the aircraft cables through the cable post to the desired
length.
To level the fixture, push the tab on the cable clutch and feed
more or less of the support cable into the cable clutch. Make
fine adjustments to each cable until the fixture is level.
If necessary, trim the excess cable from the cable post.
CAUTION: Make sure to support the fixture while
making adjustments, an assistant will be needed to
complete this step.
1D
9
CABLE CLUTCH
8
CABLE POST
9
8
9
8
AIRCRAFT CABLE
Remove the crossbar from the canopy by completely
unscrewing the thumb screw.
2 1
CROSSBAR
POWER
CORD
3
THUMB SCREW
CANOPY
1
2A
Shorten the Power Cord (optional)
Take note of the wire connections and remove the wire nuts
to disconnect the power cord wires from the driver wires.
1
3A
POWER
CORD
DRIVER