LBL Lighting Vera S - Manual (Page 3)

3
3D
#8-32
SCREW
CROSSBAR
Place all wires and wire nut connections properly inside
the electrical box.
Secure the mounting plate to the electrical box with the
two provided #8-32 screws.
2
2 2
2
Loosen the set screw on the primary strain relief.
Align the canopy center hole with the mounting plate
center hole.
Slide the canopy up against the ceiling and secure it in
place by screwing in and tightening the primary strain
relief into the crossbar. Do not turn the cord.
Push the cord into the canopy and line up the marked
point on the cord with bottom of the primary strain
relief.
Tighten the plastic set screw to secure the cord.
STRAIN RELIEF
NOTE: It is recommended that one person hold the
fixture while the electrician finishes the installation.
CORD
SET SCREW
3E
11
12
13
14
15
4A
2 1 Screw the lamps into the sockets.
Use 120 volt MAX 75 Watt
Type A19 Medium Base Lamp.
CAUTION: To reduce the risk of a burn or electric
shock during re-lamping, disconnect the power to
the fixture.
Install the Lamps, Shade, and Diffuser
SOCKET LAMP
NOTE: To re-lamp, reach in the fixture from the
opening above.