Install the pendant, Save these instructions – LBL Lighting Pendant compact fluorescent fixtures User Manual
Page 2
#4-40 SCREW
#8-32 ROUND
HEAD SCREW
BACKPLATE
CEILING
ELECTRICAL
BOX
DOME
COVER
2
CORD GRIP
CAP
DOME
COVER
1C
MARKED POINT
SLOT HEAD SCREW
Loosen the cap and feed the cord through the strain
relief. Place the strain relief right above the marked point
and tighten the slot head screw.
Slide the dome cover up against the strain relief and
tighten the cap to cord grip.
For power connection, leave at least 6" of the cord
exposed in the back of the dome canopy.
Cut off the excess cord with a sharp cutter.
STRAIN RELIEF
8
9
8
9
10
11
10
11
From the end of the cord, strip the outer insulation 4"
using a sharp knife and needlenose pliers.
Strip 1/4" of insulation from the inner insulated wires.
(three inner insulated wires for standard SVT cord). The
bare inner wire is the ground wire (green insulated wire in
SVT cord).
Make sure
not to cut inner wires.
4"
1D
12
13
12
Install the Pendant
Mount the backplate to the electrical box with the two
#8-32 round head screws. Make sure that the backplate
is grounded in accordance with local electrical codes.
Connect the ballast 120 volt black and white wires to the
120 volt hot and neutral power line wires with wire nuts
respectively.
Connect the fixture bare uninsulated wire (green in SVT
cord) to the backplate and the ballast ground wires with a
wire nut.
Connect the yellow and red ballast wires to the two
remaining fixture wires (black and white in SVT cord) with
wire nuts.
Place all wires, wire nut connections, and the ballast into
the dome cover.
Replace the dome cover onto the backplate. Replace and
tighten the two #4-40 screws.
2A
1
2
3
4
5
6
1
3
2
4
5
6
6
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.encompasslighting.com
© 2008 Encompass Lighting Group. All rights reserved. The "Encompass Lighting Group"
graphic is a registered trademark of Encompass Lighting Group. Encompass Lighting Group
reserves the right to change specifications for product improvements without notification.
A Generation Brands Company