LBL Lighting Pendant compact fluorescent fixtures User Manual
Shorten the pendant, Pendant compact fluorescent fixtures, Installation instructions for

CORD GRIP
CAP
DOME
COVER
Installation Instructions for
Pendant Compact Fluorescent Fixtures
920TDPENDCF
1
2.2
295TDSFC_CF
GENERAL PRODUCT INFORMATION:
This product is suitable for damp locations.
This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
PENDANTS
Shorten the Pendant
1A
1B
NOTE:
Refer to the instructions provided with the
pendant fixture to install the fixture shade (if needed)
before proceeding with these steps.
Feed end of the pendant cord through the cap, and cord
grip into the canopy.
Adjust the fixture height (from bottom of the fixture shade
to top of the canopy) by moving the cord up or down.
When desired height is achieved, slightly tighten the cap.
From inside mark the cord right behind the cord grip for
the strain relief location.
1
2
4
5
6
7
Remove the #4-40 screws on canopy sides.
Remove the backplate from the dome cover.
Remove the cap from the cord grip.
CORD GRIP
CAP
#4-40 SCREW
BALLAST
DOME
COVER
BACKPLATE
3
1
1
2
3
MARKED POINT
4
6
7