Flytec SensBox - Manual (Page 7)

Quick start guide SensBox
7
The example presents on the display the
altitude of 520 m, however, the actual altitude is 470 m.

For access into the Set Mode the key must be pressed for at
least 3 sec. Then the SensBox is shifted to Set Mode, the altitude
display is flashing.

By use of the arrow keys „up“ or „down“ the altitude display
can now be adjusted to the correct value – as far as known.

Either confirm the value with „OK“ , or wait for 30 sec. until the
flashing stops. The new value is automatically accepted.

If no altitude is known, but the daily updated air pressure, it is
possible to rectify this known value in mode "Air pressure".
The proceeding is identical. Afterwards the altitude display is
adjusted automatically.
Caution: all settings can also be performed by use of a small PC-Tool
SensboxConfig. The programme is available for Windows and MAC-
computers. The tool can be downloaded from our website free of charge,
or it is downloaded directly from the SD card on which it is stored, such
as this quick start guide. Please refer to Notes on page 16.