Flytec SensBox - Manual (Page 6)

Quick start guide SensBox
6
Reset: If the device does not perform as expected (crash of the firmware) one can
reset it by simultaneously pressing the keys and as well as the on-off
switch.
7. Selection and settings of diyplay mode
Handling of the SensBox is in principle self-explanatory and easy. After
switch-on the altimeter function is always displayed. The basic setting of the
altimeter is adjusted in the factory to the 1013 hPa standard. If display of the
current altitude value for the respective location is required, the SensBox must
be adjusted to the actual atmospheric pressure, such as any other barometric
altimeter. This is performed in menu item Air pressure, unless the actual altitude
value is known and can therefore be adjusted.
Each further pressing on the „OK“ key shifts to the next display mode.
In the current firmware 1.00.06 are available 9 ( 10 ) modes:

Altimeter

Variometer - optical and acoustical

Air pressure ( QNH )

Magnetic compass

GPS Speed over Ground

GPS Position

Time of day ( UTC )

Memory display

Acceleration ( momentarily not yet active )

Volume
According to the mode which is displayed, it may be necessary to execute
an adjustment of the display.
This procedure is in principle the same for most of the display
modes. Therefore it is exemplarily described and illustrated
here in detail only once.
At this point the correction of altitude display is described.
As the altitude display is changed according to atmospheric pressure,
it is necessary to perform a correction in order to have a correct barometric
altitude display during a flight.