Flytec SensBox - Manual (Page 5)

Quick start guide SensBox
5
5. Switching on/and -off the SensBox
Please press the On/Off key, the display shows „ON“, then press the „OK“ key for
confirmation. The instrument will then automatically switch to operation mode
via display of the device's serial number and of the installed firmware version.
Switch-off: if the Switch-on/-off key is pressed for at least 3 sec., the display shows
„OFF“, which is then confirmed with „OK“. By this process all data are stored on
the SD card.
6. Firmware update
In general the SensBox is provided with the current firmware. However, because
time and again improvements, or the removal of bugs require an adaptation of the
firmware, it is recommended to watch for the currently valid firmware.
Upload of a new firmware: Switch-off the instrument. Insert the SD card with
the new firmware file into the device.
Press the key and simultaneously press a long time the Switch-on/-off key.
The device queries OK? -> Confirm by pressing the key.