Inbound authentication, Vg3300 – Accton Technology SIP Gateway VG3300 Series User Manual
Page 42

VG3300
series user guide
11.3. Inbound Authentication
You need to configure inbound authentication if you request authentication for other SIP phone to 
call you. 
Configuration 
WEB Page: ADVANCED \ SIP INBOUND AUTHENTICATION 
11.4. FAX
For VG3300 software version 1.05 or above, SIP-based T.38 Fax protocol is applied. Any brand SIP 
gateway with SIP-based T.38 Fax protocol can transmit FAX with each other. T.38 is FAX protocol 
and it has better performance and better successful transmission rate. However, SIP device that 
does not support SIP-based T.38 still can transmit and receive FAX with VG3300 by G.711 codec. 
G.711 codec uses more bandwidth, so it may not as good as SIP-based T.38 protocol if bandwidth 
control is the key factor of the network. 
 
Setup method is listed below: 
1. Web folder: “Channel” 
Enable T.38 Fax Relay support. Configure it to Yes
 
2. Warm-Restart the system 
Note: For FAX transmission, two gateways will change to SIP-Based T.38 Protocol automatically if 
39
