Asus DiGiMatrix AB-V10 - Manual (Page 23)

2-5 ASUS DiGiMatrix
3. Connect the 40-pin IDE cable to the IDE connector on the drive.
4. Connect the 4-pin power plug to the HDD power connector.
5. Place the drive on the tray. Insert the tray metal tacks into the drive
screw holes (two at the side and two at the bottom).
6. Secure the drive with two side screws.
3
4
5
6
Metal tacks
(To side of the drive) Metal tacks
(To bottom of the drive)
Insert the side metal tacks before inserting the bottom metal tacks.
7. Replace the metal cover by aligning its side hooks with the tray rail
and optical drive shield. Slide the metal cover toward the front panel
until it fits in place.
7