Asus DiGiMatrix AB-V10 - Manual (Page 150)

Appendix A-4
A.1.4 Connecting the Subsystem to DiGiMatrix
Follow these instructions to connect the Subsystem to the DiGiMatrix.
4
1. Place the Subsystem on top of the DiGiMatrix.
2. Connect one end of the IDE cable to the DiGiMatrix IDE connector.
3. Loosen one top cover screw on the DiGiMatrix, then insert the IDE
cable ground terminal into the screw. Tighten the screw.
4. Connect the other end of the IDE cable to the Subsystem IDE
connector.
5. Loosen one top cover screw on the Subsystem, then insert the IDE
cable ground terminal into the screw. Tighten the screw.
6. Connect one end of the DC power cable to the DiGiMatrix DC OUT
socket.
7. Connect the other end of the DC power cable to the Subsystem DC
IN socket.
1
2
3
5
6
7