Switching off and disconnecting the appliance, Switching off the appliance, Disconnecting the appliance – Siemens KG39FSB30 User Manual
Page 36: Defrosting, Refrigerator and “cool-fresh” compartments, Freezer compartment, Cleaning the appliance, M caution
en
36
Switching off and
disconnecting the
appliance
Switching off the appliance
Fig. 2
Press the On/Off button 1.
Temperature display goes out,
refrigerating unit switches off.
Disconnecting the appliance
If you do not use the appliance
for a prolonged period:
1. Switch off the appliance.
2. Pull out mains plug or switch off fuse.
3. Clean the appliance.
4. Leave the appliance door open.
Defrosting
Refrigerator and “cool-fresh”
compartments
Defrosting is actuated automatically.
While the refrigeration unit is running,
water droplets or hoarfrost form
at the rear panel of the refrigerator
compartment. This is nothing unusual. It
is not necessary to wipe off the water
droplets or hoarfrost. The rear panel
defrosts automatically. The condensation
drains off into the condensation channel,
Fig. ,. From there the condensation
drains off down the condensation
channels to the refrigeration unit where it
evaporates.
Note
Keep the condensation channel
and drainage hole clean, so
the condensation can drain off. Fig. ,
Freezer compartment
The fully automatic No Frost system
ensures that the freezer compartment
remains free of ice. Defrosting is no
longer required.
Cleaning the appliance
ã=
Caution
■
Do not use abrasive, chloride or acidic
cleaning agents or solvents.
■
Do not use scouring or abrasive
sponges. The metallic surfaces could
corrode.
■
Never clean shelves and containers in
the dishwasher. The parts may
become deformed!
Proceed as follows:
1. Before cleaning: Switch the appliance
off.
2. Pull out the mains plug or switch off
the fuse.
3. Take out the frozen food and store in
a cool location.
4. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light.
5. Wipe the door seal with clear water
only and then wipe dry thoroughly.
6. Rinsing water must not run through
the drainage hole into the evaporation
area.
7. After cleaning reconnect and switch
the appliance back on.