Siemens TK76K573 - Manual (Page 48)

48
de en
Open drawer
Deploy the appliance and open the
drawer (17).
Insert cleaning tablet! Close drawer!
Drop a cleaning tablet in the drawer and
close the drawer again.
Press start
Press start stop (8). The cleaning
programme will now run for about seven
minutes.
Cleaning
Empty drip tray
Empty the drip tray.
Replace drip tray
Replace the drip tray.
The appliance is ready for use again.
Calc‘n‘Clean
Calc‘n‘Clean combines the separate
functions of descaling and cleaning. If the
two programmes are both due to run soon,
the fully automatic espresso machine
suggests this service programme
automatically.
If the prompt
Service - Calc‘n‘Clean
is
displayed, press and hold down
i
(7) for
at least three seconds. The display shows:
Please press ‘Start/Stop’ to begin...
Calc‘n‘Clean
or
To start without the prompt (see “Displaying
Settings”) press and hold down
i
(7) for
at least three seconds and select
Please press ‘Start/Stop’ to begin...
Calc‘n‘Clean
Press start stop (8). The display
will guide you through the programme.
Empty drip tray
Empty the drip tray (20).
Replace drip tray
Replace the drip tray.
If the milk frother is not inserted,
the following message is dis-
played:
Set up milk frother
Insert the milk frother (10).
Place container under milk frother
–▸ Start
Place a container with a capacity of at
least one litre under the milk frother
(10).
Press start stop (8). The appliance
rinses twice:
Cleaning
Open drawer
Deploy the appliance and open the
drawer (17).
Insert cleaning tablet! Close drawer!
Drop a cleaning tablet in the drawer and
close the drawer again.
If the water ilter is activated, the
following message is displayed:
Remove filter –▸ Start
Remove the water ilter and press
start stop (8).
Add 0.5 l water and descaler –▸ Start
Pour lukewarm water into the empty
water tank (12) up to the calc (0.5 litre)
mark and dissolve two descaling tablets
in it. Press start stop (8). The
descaling programme now runs for
about 20 minutes:
Descaling
If there is not enough descaling
luid in the water tank, the follow-
ing message is displayed:
Not enough descaling fluid
Refill fluid
Pour lukewarm water into the empty water
tank (12) up to the calc (0.5 litre) mark
and dissolve two descaling tablets in it.
Press start stop (8). The descaling
programme will continue.