Siemens TK76K573 - Manual (Page 47)

47
de en
Descaling
If the prompt
Service - descale
is
displayed, press and hold down
i
(7) for
at least three seconds. The display shows:
Please press ‘Start/Stop’ to begin...
Descaling program
or
To start without the prompt (see “Displaying
Settings”) press and hold down
i
(7) for
at least three seconds and select
Please press ‘Start/Stop’ to begin...
Descaling program
Press start stop (8). The display
will guide you through the programme.
Empty drip tray
Empty the drip tray (20).
Replace drip tray
Replace the drip tray.
If the milk frother is not insert-
ed, the following message is
displayed:
Set up milk frother
Insert the milk frother (10).
Place container under milk frother
–▸ Start
Place a container with a capacity of 0.5
litres under the milk frother (10). Press
start stop (8).
If the water ilter is activated, the
following message is displayed:
Remove filter –▸ Start
Remove the water ilter and press
start stop (8).
Add 0.5 l water and descaler –▸ Start
Pour lukewarm water into the empty
water tank (12) up to the calc (0.5 litre)
mark and dissolve two descaling tablets
in it. Press start stop (8). The
descaling programme now runs for
about 20 minutes:
Descaling
If there is not enough descaling
luid in the water tank, the follow-
ing message is displayed:
Not enough descaling fluid
Refill fluid
Pour lukewarm water into the empty water
tank (12) up to the calc (0.5 litre) mark
and dissolve two descaling tablets in it.
Press start stop (8). The descaling
programme will continue.
Clean and refill water tank –▸ Start
Rinse the water tank and reill it with fresh
water up to the “max” mark.
Press start stop (8). The descaling
programme will now run for about 1
minute:
Descaling
Empty drip tray
Empty the drip tray.
Replace drip tray
Replace the drip tray.
Replace the ilter if one is being used.
The appliance is ready for use again.
Cleaning
If the prompt
Service - clean
is displayed,
press and hold down
i
(7) for at least
three seconds. The display shows:
Please press ‘Start/Stop’ to begin...
Cleaning program
or
To start without the prompt (see “Displaying
Settings”) press and hold down
i
(7) for
at least three seconds and select
Please press ‘Start/Stop’ to begin...
Cleaning program
Press start stop (8). The display
will guide you through the programme.
Empty drip tray
Empty the drip tray (20).
Replace drip tray
Replace the drip tray.
Cleaning