Siemens LU17122 - Manual (Page 25)

Before installation
ṇ
To prevent damage to the fan, hold the
tool vertically.
❑ Remove the broken off metal part
(possibly a noisy and disruptive
procedure).
❑ If the extractor hood has 2 motors, the
opening on the plastic part must be
made at the rear; cut through the 3 ribs
and remove the cut-off part.
Exhaust air towards the rear:
Pipe diameter: 100 mm
❑ Break off cover on the rear panel of the
extractor hood; strike the retaining
points with a tool.
❑ Cut off the outer part of the exhaust-air
connection.
❑ Insert the inner part and turn as far as
possible.
Circulating-air mode
❑ With activated carbon filter if exhaust-air
mode is not possible.
❑ The air purified by an additional
activated carbon filter is conveyed back
into the room.
❑ For insertion of the activated carbon
filter see Instructions for use.
❑ If the extractor hood is switched from
exhaust-air mode to circulating-air
mode, the exhaust-air opening must be
sealed to prevent a hazardous situation
(see optional accessories in the
Instructions for use).
Electrical connection
WARNING: THIS APPLIANCE MUST BE
EARTHED
IMPORTANT: Fitting a Different Plug:
The wires in the power cord are colour-
coded as follows:
Green and Yellow – Earth
Blue – Neutral
Brown – Live
If you fit your own plug, the colours of these
wires may not correspond with the identify-
ing marks on the plug terminals.
Proceed as follows:
1. Connect the green and yellow (Earth)
wire to the terminal in the plug marked
‘E’ or with the symbol ( ), or
coloured green or green and yellow.
2. Connect the blue (Neutral) wire to the
terminal in the plug marked ‘N’ or
coloured black.
25