Siemens DE2427555 - Manual (Page 12)

12
en
Please read the operating instructions carefully before you use the appliance!
Please observe the enclosed instructions.
Safety information
Risk of electric shock!
Switch off the mains voltage supply immediately if a fault occurs.
We do not accept liability for damage resulting from failure to heed these instructions. ■
The installation and initial start-up must be undertaken by a specialist who complies with these
■
installation instructions.
Repairs may only be undertaken by a suitably qualified specialist to avoid potential sources of danger. ■
The continuous-flow heater may only be installed in a frost-free room. ■
Persons (including children) with diminished bodily, sensory or mental perception, or those who lack ■
knowledge or experience should not operate the appliance, unless they are monitored or have received
instruction concerning use of the appliance by persons responsible for their safety.
Keep children away from the appliance. Please monitor children to ensure that they do not play with the ■
appliance.
The mixer and the warm water pipe may be hot. ■
Please switch off all fuses immediately with a malfunction. Immediately shut off the cold water supply to ■
the appliance should it leak. The malfunction can only be repaired by a specialist or an authorised service
agent.
Your new appliance
The electronic continuous-flow heater is intended exclusively for heating water which flows through the
appliance.
The continuous-flow heater switches on and heats the water when the warm water tap is opened. It switch-
es off as soon as the tap is closed.
Operating the continuous-flow heater
The default temperature for the water temperature after the first start-up or a power failure is 40 °C.
Selecting shower temperature
Select the required temperature with the rotary knob used to vary
the desired temperature from 20 °C to 60 °C in steps of 0.5 °C.
The coloured display lighting indicates the temperature range dur-
ing operation by means of blue or red hues.
Info: The temperature shown in the display is the water tempera-
ture inside the appliance. The temperature of the water leaving
the tap can vary from this due to heat losses in the pipework.