Matrix Orbital LK202-24-USB - Manual (Page 38)

Command Syntax Default Notes
Block cursor off FE 54
254 84
254 “T” R Turns off the
blinking block
cursor.
Cursor left FE 4C
254 76
254 “L” Moves the cur-
sor one position
to the left. If the
cursor is already
at the beginning
of a line it will
move to the end
of the other line.
Cursor right FE 4D
254 77
254 “M” Moves the cur-
sor one position
to the right. If the
cursor is already
at the end of a line
it will move to the
beginning of the
other line.
8.5 Keypad Interface Commands
NOTE The letter “R” in the default column indicates that this state can be saved to non-
volatile memory with the “Remember” command.
Table 27: Keypad Interface Commands
Command Syntax Default Notes
Auto repeat mode on FE 7E [0x00 | 0x01]
254 126 [0|1]
254 “~”[0|1] off
R Applies to keypad
only.
0x00 = 200 ms
typematic, 0x01 =
key down / key up
codes sent.
Auto repeat mode off FE 60
254 96
254 “‘” off
R Applies to keypad
only.
Matrix Orbital LK202-24-USB 34