Matrix Orbital LK402-25 - Manual (Page 31)

31
6.6. Set Auto Repeat
Mode
Dec
Hex 254 126
FE 7E
Mode
Mode
Sets key press repeat mode to typematic or hold. In typematic mode if a key press is held, the key value is
transmitted immediately, then 5 times a second after a 1 second delay. In hold mode, the key down value is
transmitted once when pressed, and then the key up value is sent when the key is released. Default is typematic.
Mode 1 byte, 1 for hold mode or 0 for typematic
6.7. Auto Repeat
Mode Off
Dec
Hex 254 96
FE 60
Turns auto repeat mode off. Default is on (typematic).
6.8. Assign Keypad
Codes
Dec
Hex 254 213
FE D5
Key Down Key Up
Key Down Key Up
Assigns the key down and key up values sent to the host when a key press is detected. A key up and key down
value must be sent for every key, a value of 255 will leave the key unaltered. Defaults are shown below.
Key Down 25 bytes, key down values
Key Up 25 bytes, key up values
Table 26: Default Key Down Values
Key Down
A(65) B(66) C(67) D(68) E(69)
F(70) G(71) H(72) I(73) J(74)
K(75) L(76) M(77) N(78) O(79)
P(80) Q(81) R(82) S(83) T(84)
U(85) V(86) W(87) X(88) Y(89)
Table 27: Default Key Up Values
Key Up
a(97) b(98) c(99) d(100) e(101)
f(102) g(103) h(104) i(105) j(106)
k(107) l(108) m(109) n(110) o(111)
p(112) q(113) r(114) s(115) t(116)
u(117) v(118) w(119) x(120) y(121)