Matrix Orbital LK402-25 - Manual (Page 18)

18
Common Features
General Purpose Outputs
Figure 17: GPO Header
Table 16: GPO Pinout
Pin Function Pin Function
1 GPO 1 8 Gnd
2 GPO 1 9 Gnd
3 GPO 1 10 Gnd
4 GPO 1 11 Gnd
5 GPO 1 12 Gnd
6 GPO 1 13 Gnd
7 Vcc 14 Gnd
A unique feature of the LK402-25 is the ability to control relays
* and other external devices using one of
six General Purpose Outputs. Each can source up to 20mA of current at five volts when on or sink 10mA
at zero volts when off. The two row, fourteen pin header can be interfaced to a number of female
connectors to provide control to any peripheral devices required.
*Note: If connecting a relay, be sure that it is fully clamped using a diode and capacitor in order to absorb any
electro-motive force (EMF) which will be generated.
Dallas One-Wire Connector
Figure 18: Dallas One-Wire Connector
Table 17: Dallas One-Wire Pinout
Pin Function
1 Vcc
2 D
3 Gnd
In addition to the six general purpose outputs the LK402-25 offers an Optional Dallas One-Wire bridge,
to allow for an additional thirty two one-wire devices to be connected to the display. This header can be
populated with a Tyco 173979 connector at an added cost by custom order only. Please use the Contact
section to request for more information from the Matrix Orbital sales team.