Wagner PaintREADY System - Manual (Page 4)

English 4
Assembly
Start
1. Align the arrow on the spray gun
with the “unlock” symbol on the
spray gun handle.
4. Insert the air hose tightly into the
connection into the turbine. The
connections can be positioned as
desired.
2. Insert and twist the spray gun
into the handle toward the “lock”
symbol on the spray gun handle.
The tab below the trigger will
lock the two pieces into place.
5. align the suction tube -
If you are going to be spraying in
a downward direction, the angled
end of the suction tube should be
pointing toward the front of the
gun.
3. Insert the air hose tightly into
the connection on the spray
handle. The connection can be
positioned as desired.
6. If you are going to be spraying in
an upward direction, the angled
end of the suction tube should be
pointing toward the rear of the
gun.
Your unit includes two spray guns. See below to
determine the correct spray gun for your spraying
project.
Yellow spray gun -
designed for spraying
thinner materials, such
as oil-based stains and
thinned paints. The
yellow spray gun leaves a
smooth finish.
white spray gun -
designed for spraying
thicker materials, such as
latex paints and stains.
Spraying with this gun will
leave a slightly coarser
finish that is between
a roller and fine-finish
sprayer.
note: These two spray guns have different spray
pattern / width controls. Make sure to familiarize
yourself with the controls on each spray gun
head. See the “Spraying” section, page 6-7.
Notice:
1
4
2
5
3
6