Wagner PaintREADY System - Manual (Page 11)

English 11
Troubleshooting any attempt to open the motor housing or repair any electrical parts within the
unit by anyone other than an authorized repair technician could cause serious
injury and will void the warranty.
This unit contains no servicable electrical parts. Do
not attempt to service yourself. Store indoors with
the cord wrapped around the turbine handle.
Problem A: Little or no material flow
Cause Solution
1. Nozzle clogged. Clean.
2. Suction tube clogged. Clean.
3. Material volume setting turned too low (-). Increase volume setting (+).
4. Suction tube loose. Insert.
5. No pressure build up in container. Tighten container.
6. Air filter clogged. Change.
Problem B: Material leaking
Cause Solution
1. Nozzle loose. Tighten.
2. Nozzle worn. Replace.
3. Nozzle seal worn. Replace.
4. Material build-up on air cap and nozzle Clean.
Problem C: Spray pattern too thick, runs and sags
Cause Solution
1. Viscosity of material too high. Thin.
2. Material volume too large. Decrease volume setting (-).
3. Material volume setting too high (+). Decrease volume setting (-).
4. Pressure setting too low. Increase pressure setting (+).
5. Nozzle clogged. Clean.
6. Air filter clogged. Change.
7. Too little pressure build-up in container. Tighten container.
Problem D: Spray jet pulsates
Cause Solution
1. Material in container running out. Refill.
2. Air filter clogged. Change.
Problem E: Pattern runs or sags
Cause Solution
1. Applying too much material.
Adjust material flow or increase
movement of spray gun.
Problem F: Too much overspray
Cause Solution
1. Gun too far from spray object. Reduce distance.
2. Too much material applied. Decrease volume setting (-).
3. Pressure setting too high. Decrease pressure setting.
Problem G: Pattern is very light and splotchy
Cause Solution
1. Moving the spray gun too fast.
Adjust material flow or
decrease movement of spray
gun.
Have you tried the recommendations above and are still having
problems? In the United States, to speak to a customer service
representative, call our Technical Service at 1-800-328-8251 Monday
through Friday between 8:00 aM and 4:30 PM Central time.