Assembly – Waterloo F1526A2 User Manual

Page 4

BB(2)

EE(2)

FF(2)

• Remove and reuse the top fasteners from the top back of

the workbench.

• Attach (2) A to workbench, as shown, using existing

hardware and (2) BB, (2) EE and (2) FF.

• Finger tighten.

Existing Hardware

Flange
pointed back

STEP 1:

Stop

Lance

Slot

Lubricate

• Empty the drawer.
• Fully extend the drawer.

Release

• To reinstall, carefully align

the slides and slowly push
the drawer into the unit until
the drawer stops.

Lever Style - Lift or lower (depending on the
slide) the release lever on both sides, (this
allows the slides to ride over the stops.) Pull
out to remove.

Tab Style - Depress the release tabs on
both sides, (this allows the slides to ride over
the stops.) Pull out to remove.

WARNING: Backwall with Metal Pegboard is only to be attached to
one of the following Workbenches: WB5002, WB5003, WB5507.

NOTE: To assemble the Backwall, the drawers and top must first be
removed from the workbench.

REMOVING AND INSTALLING DRAWERS:
FRICTION SLIDES

• Empty the drawer.
• Fully extend the drawer. Push it back a quarter of an inch, (6

mm).

• Insert a screwdriver into the slot in the slide and push in on the

stop until it clears the lance.

• Repeat the procedure on the other slide and remove the drawer.
• To reinstall the drawer, pry the stop far enough out to engage the

lance and push the drawer onto the slides until the stops pass
over the lances.

BALL BEARING SLIDES

TOP REMOVAL:
• Remove and reuse fasteners from wood top.
• Remove top from workbench base.

ASSEMBLY