Waterloo F1882 - Manual (Page 4)

Friction Style - Fully extend the drawer. Insert screwdriver
into the slot in the side and push in on the stop until it
clears the lance. Pull drawer just past lance before releas-
ing stop. Repeat the process for the other slide.
Tab Style - Depress the release tabs on both sides,
(this allows the slides to ride over the stops.) Pull out to
remove.
• Empty the drawer.
• Fully extend the drawer.
REMOVING DRAWERS
Lever Style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops.) Pull out to remove.
NOTE: Not all operation instructions will relate to your
model.
To reinstall the drawer, pry the stop far enough out to
engage the lance (3/16" to 1/4") and push the drawer onto
the slides until the stops pass over the lances.
4
OPERATION
Release
Slot
Stop
Lance
Lubricate
Lock Bar
Slot
Fit into slot on
the bottom side
of the sheet
metal top
LOCKING BAR
NOTE: The locking bar is stored in the slot located in the
back corner of the plastic top, or inside a drawer (depend-
ing on your unit).
• To lock the drawers, insert the top end of the lock bar
through the slot in the top of the unit and over the staple
on the base (or depending on your unit, you may need
to insert the top end of the lock bar above the top drawer
and then over the staple on the base).
• To secure, lock with a padlock. (Padlock not included.)
• To unlock the drawers, reverse this procedure.