Midco RE32 - Manual

MIDCO International Inc.
4140 WEST VICTORIA STREET, CHICAGO, ILLINOIS 60646 / (773) 604-8700 FAX: (773) 604-4070 / http://www.midco-intl.com
The ECONOMITE Model RE32 intermittent spark ignition conversion burner is adaptable to most gas utilization equipment,
including gravity and forced circulation furnaces and boilers, and is particularly recommended for horizontal and downdraft gas
utilization equipment since it needs no draft to maintain a pilot. Power burner design makes it perfectly suited for oil burner
replacement.
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
● Do not try to light any appliance
● Do not touch any electrical switch;
do not use any phone in your building.
● Immediately call your gas supplier
from a neighborÕs phone. Follow the
gas supplierÕs instructions.
● If you cannot reach your gas
supplier, call the fire department.
Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
INSTALLATION AND
SERVICE INSTRUCTIONS
ECONOMITE MODEL RE32
Gas Conversion Burner
PRINTED IN U.S.A.
197
8470-01
WARNING: If the information in
these instructions is not followed
exactly, a fire or explosion may
result, causing property damage,
personal injury, or death.
In the United States, installation must conform with local codes or,
in the absence of local codes, with Installation of Domestic Gas
Conversion Burners, ANSI Z21b-latest edition, and National
Fuel Gas
Code, ANSI Z223.1-latest edition, available from
American National Standard Institute. Further reference should
be made to the recommendation of your fuel supplier.
NOTE: Any additions, changes, or conversions required in order for
the gas utilization equipment to satisfactorily meet the application
needs must be made by a MIDCO distributor (or other qualified
agency) using factory specified and approved parts.
In Canada, installation must conform with local codes or, in the
absence of local codes, with Installation Codes for Gas Burning
Appliances and Equipment, CGA Standard CAN/CGA 1-B149.1
or 2. When the conversion burner is used on Forced Air Central
Furnace, the two yellow and black warning labels in the literature
envelope shall be attached in accordance with Installation Code,
CGA Standard CAN/CGA 1-B149, Clause 5.4.4.4. Further
reference should be made to the recommendation of your
fuel
supplier.
INSTALLER: Inform and demonstrate to the
user the correct operation and maintenance of
this gas utilization equipment. Inform the user
of the hazards of storing flammable liquids
and vapors in the vicinity of this gas utilization
equipment and remove such hazards. Affix
this manual adjacent to the conversion burner.
CODE COMPLIANCE IS THE SOLE
RESPONSIBILITY OF THE INSTALLER.
USER: Retain this manual for future reference.
If other than routine service or maintenance
as described in this manual is required,
contact a qualified service agency. DO NOT
ATTEMPT REPAIRS. An inadvertent service
error could result in a dangerous condition.
SAFETY INFORMATION TERMS: The following terms are used to identify hazards, safety precautions or special notations and have
standard meanings throughout this manual. When you see the safety alert symbol and one of the safety information terms, as
shown below, be aware of the hazard potential.
DANGER: Identifies the most serious hazards which will result in severe personal injury or death.
WARNING: Signifies a hazard that could result in personal injury or death.
CAUTION: Identifies unsafe practices which would result in minor personal injury or product and property damage.
ANSI Z21.17
CONVERSION
BURNERS