Videotec HTG - Manual (Page 6)

EN - English - I
nstruc
tions manual
4
5.3 Safely disposing of
packaging material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.
6 Assembling and
installing
g h Only specialised personnel should be
allowed to assemble and install the device.
6.1 Installation
6.1.1 How to open the housing
To open the housing, unscrew the 3 screws on the
rear cover plate and loosen the two dowels on the
outer slide, then slide out the housing body.
Fig. 01
This will give easy access to the inside of the housing,
without dismantling it from the support bracket.
6.1.2 How to install the camera
This section describes how to install the camera
inside the housing. It should be remembered that the
power supply can be taken off the circuit supplied
with the housing, after checking its suitability.
Open the housing as in the instructions above ("6.1.1
How to open the housing", page 4).
5 Preparing the product
for use
g h Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.
5.1 Safety precautions before
use
g g In the 120/230Vac powered configuration
it is necessary to insert a 1 0 unipolar
main switch (open contact distance
d>3mm) upstream on the power line. This
switch should be used to disconnect the
power supply before carrying out any
maintenance operation or before opening
the housing.
5.2 Contents and unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• HTG housing
• Housing equipment:
• Allen wrench
• Spacers
• Cable glands
• Cable glands gaskets
• Screws and washers
• Screws for camera
• Desiccant salt bag
• Instructions manual