Phottix Atlas II - Manual (Page 5)

5
En INSTRUCTION MANUAL
1. To turn on the Phottix Atlas II – move the
power switch to the “ON” position.
2. To turn off the Phottix Atlas II – move the
power switch to the “OFF” position.
1. Set the Transmit / Receive Mode Switch to Tx
for transmit mode. This can be used on a
camera hot shoe to trigger remote flashes or to
take photos when using the Atlas II as a wire-
Turning units on/off
Setting Channels
Setting Transmit or Receive Mode
less remote shutter release.
2. Set the Transmit / Receive Mode Switch to
Rx for receive mode. This can be used to
trigger remote flashes or cameras when using
the Atlas II as a wireless remote shutter release.
1. The Phottix Atlas II has four channel settings.
2. Move the Channel Selector Switch to 1, 2, 3,
or 4 to select a channel.
3. Make sure all Phottix Atlas II transceivers,
b o t h o n t h e c a m e r a a n d a t t a c h e d t o
flashes/strobes, are on the same channel.
4. Atlas II transceivers in Rx (receive) mode set
to channels different from the channel set on
the Atlas II set to Tx (transmit) mode will not
fire.
transmit or receive signals. The LED will turn
solid red when a signal is sent or received.
2. When the battery power is very low, the
Status LED will flash green light every 0.5
seconds. Please change the batteries (see
above).