American Dryer Corp. ML-75V - Manual (Page 42)

38
10. Reversing Models Only - Basket (tumbler) dryer should never be operated with less than a 50 lb (22.67
kg) load dry weight. The size of the load will affect the coast-down and dwell (stop) times. The basket
(tumbler) must come to a complete stop before starting in opposite direction.
a. Microprocessor Models
1) Spin and dwell (stop) are not adjustable in the Automatic Mode and have been preprogrammed into
the microprocessor controller (computer) for 150-seconds spin time in forward direction, 120-seconds
in the reverse direction and a 5-second dwell (stop) time.
2) Spin and dwell (stop) times are adjustable in the Manual (timed) Mode.
b. Dual Timer Models
1) Both dwell (stop) and basket (tumbler) spin time are adjustable. (Refer to the illustration on page
48.)
11. Check to insure that ALL setscrews (i.e., basket [tumbler] drive, idler, etc.) are tight.
K. PREOPERATIONAL INSTRUCTIONS
1. To start the dryer:
a. Microprocessor Controller (Computer) Dryers...
1) Light emitting diode (L.E.D.) display will read “REAdY” (meaning no cycle in progress).
2) Press the letter on the keyboard (touch pad) corresponding to the cycle desired (i.e., key “E”)...
a) The dryer will then start (rotate).
3) L.E.D. display will now show “Cycle In Progress” and “Cycle Status” meaning that the dryer is in
the drying cycle (dry mode for 30 minutes) and count downwards in minutes.
NOTE: Pressing keyboard (touch pad) key “A” “B” “C” “D,” or “F” will also start the dryer. The six
(6) preprogrammed drying cycles “A” through “F” have been stored in the microprocessor
controller (computer) memory. Refer to the Programming Manual supplied with the dryer for
more specific operating instructions.
NOTE: The dryer can be stopped at any time by opening the main door or by pressing the “STOP”
red key. To restart the dryer, press the “START” green key or a preprogrammed cycle key
(i.e., “E”).
NOTE: Selection (settings) changes can be made at any time during the drying cycle by pressing the
“STOP” red key twice. The L.E.D. display will return to “REAdY” at which time a new cycle
selection can be made.