Kenwood TK-3160E - Discontinued User Manual

Page 18

If you are not using a speaker/
microphone, install the cover over
the speaker/ microphone jacks by
sliding the cover’s tab into the slot
on the side of the transceiver until
it snaps in place.

Note: To keep the transceiver water
resistant, you must cover the
speaker/ microphone jacks with the
supplied cover.

NSTALLING

THE

OVER

THE

PEAKER

/ M

ICROPHONE

ACKS

Note: When installing the speaker/ microphone jack cover, you must
remove the battery pack from the rear of the transceiver.

NSTALLING

THE

PTIONAL

) S

PEAKER

/ M

ICROPHONE

Note: When installing the optional speaker/ microphone and its
locking bracket, you must remove the battery pack from the rear of
the transceiver.

1 Insert the speaker/

microphone plugs into the
speaker/ microphone jacks.

2 Attach the locking bracket

using the supplied screw.

Note: To lift the locking bracket after
it has been installed, use a piece of
hardened plastic or metal, such as a
small screwdriver. Lift the bracket by
its tab, beside the screwhole, taking
care not to damage the bracket.