Kenwood TK-3160E - Discontinued User Manual

Page 16

NSTALLING

/ R

EMOVING

LKALINE

ATTERIES

◆ Do not install batteries in a hazardous environment where sparks

could cause an explosion.

◆ Never discard old batteries in fire; extremely high temperatures

can cause batteries to explode.

◆ Do not short circuit the battery case terminals.

◆ Do not use commercially available rechargeable batteries.

Note:
◆ If you do not plan to use the transceiver for a long period, remove

the batteries from the battery case.

◆ This battery case has been designed for transmitting at a power

of approximately 1 W (the low power setting on your transceiver).
If you want to transmit a stronger signal (using the high power
setting on your transceiver), use an optional rechargeable battery
pack.

1 To open the battery case,

press on the 2 tabs on the
upper rear of the case then
pull the 2 halves apart.

2 Insert 6 AA (LR 6) alkaline

batteries into the battery
case.

•

Be sure to match the polarities
with those marked in the bottom
of the battery case.

3 Align the tabs of the cover

with the base, then push
down on the cover until it
locks in place.