Kenwood TK-3170E6 - Manual (Page 41)

34
EMERGENCY CALLS
If your transceiver has been programmed with the Emergency
function, you can make emergency calls.
Note: Only the Auxiliary (orange) key can be programmed with the
Emergency function.
1 Press and hold the key programmed as Emergency.
• Depending on the delay time programmed into your
transceiver, the length of time you must hold the Emergency
key will vary.
• When the transceiver enters Emergency mode, the
transceiver will change to the Emergency channel and begin
transmitting based on how the transceiver is set up by your
dealer. Transmit periods are also set by your dealer.
2 To exit Emergency mode, press and hold the Emergency
key again.
• If the Emergency mode completes the preset number of
cycles, Emergency mode will automatically end and the
transceiver will return to the channel that was in use before
Emergency mode was entered.
Note:
◆ Your dealer can set the transceiver to emit a tone when
Emergency mode starts and stops
◆ Your dealer can set the transceiver to emit tones and received
signals as normal or mute the speaker during Emergency
operation.
L
ONE
W
ORKER
E
MERGENCY
M
ODE
Lone Worker mode is an Emergency feature for use when you
are entering a dangerous atmosphere, such as a fire or
tunnel. Once activated, the transceiver will continue to
transmit the Lone Worker Emergency tone until Lone Worker
mode is turned OFF.
Press and hold the key programmed as Lone Worker for 2
seconds to toggle Lone Worker mode ON and OFF.